SNMP Configuration || How to enable and configure SNMP || How to configure SNMP in OLT || Shafi360
#Shafi360
#snmp
In this video, we will show How to Configure SNMP.
By this video, you will be able to configure Switch/Olt & make operational at basic level. If anyone need anymore help, can call +8801740930198
Please SUBSCRIBE My Channel. .
YouTube: https://www.youtube.com/channel/UCWDiE1byMe_oRD21-UwHUdw?sub_confirmation=1
You can follow us on Facebook also;—
Facebook: https://www.facebook.com/shafi360.com.bd/?ref=pages_you_manage
——————————————————–
———————————————————
::::::::::::::BDCOM SWITCH/OLT::::::::::::::::::::::::::::::::::::
How to configure SNMP in OLT
Switch#config
Switch_config#snmp-server community 0 BDCOM RW
Switch_config#snmp-server host 172.16.22.3 BDCOM authentication configure snmp
Switch_config#exit
Switch#write all
NB: Here “BDCOM” is the community name and the IP 172.16.22.3 is your PC IP
Simple Network Management Protocol (SNMP) is a standard protocol used for the communication and management of network devices connected over an IP. With a set of standards, SNMP collects data from different hardware and software, organizes them, and aids in network fault detection and analysis. Most of the network devices like routers, switches, firewalls, printers, servers, CCTV cameras, and wireless access points are SNMP-enabled, and they send the performance data for monitoring. Thus, SNMP an integral part of interoperability between both the monitored and the monitoring systems.
SNMP protocol is an application layer protocol defined by the Internet Architecture Board in RFC1157. SNMP is used to exchange management information between network devices. It is one of the most common protocols used for network management. SNMP is part of the Transmission Control Protocol/Internet Protocol (TCP/IP) suite as defined by the Internet Engineering Task Force.
Organizations use SNMP to monitor and manage devices on a local area network (LAN) or wide area network (WAN). Most network devices in the market come bundled with SNMP agents. If not, some devices also allow network admins to install the agents.
SNMP generally uses User Datagram Protocol (UDP) port number 161/162. An SNMP port is the SNMP communication endpoint. It is a logical construct that identifies SNMP data transfer. SNMP message transfer happens via UDP. The Transport Layer Security (TLS) or Datagram Transport Layer Security (DTLS) protocols are also used at times.
Tags:
snmp protocol,snmp,snmp configuration,configure snmp,how to enable snmp,how to configure snmp,how to configure snmp in olt,snmp configuration on cisco switch,snmp configuration on packet tracer,olt configuration,epon olt configuration commands,epon,gpon,olt,onu,how to enable and configure snmp,configure snmp in olt,shafi360,epon olt 4 port,cdata olt vlan configuration,cdata olt configuration,snmp configuration in olt,setup snmp,snmp server,snmp setup
source by Shafi360
simple network management protocol
