CCNA | Lab 8 | Packet Tracer | Routing | Configure Static Routing using Default Route Command
How to Configure Static Routing using Default Route Command using Cisco Packet Tracer?
Contents:
00:00 – Lab Introduction
00:32 – Topology Diagram
02:17 – Configure IP Address on PCs
03:40 – Configure IP Address on Router Interfaces
07:28 – Configure Default Static Routes
12:15 – Checking Connectivity
12:49 – Simulation Mode
=========================================================
Reference Video 1: How to Configure IP Address on a Router Interfaces?
Reference Video 2: How to Configure Static Routing?
=========================================================
Cisco
CCNA
Default Route
Routing
Network
Networking
Burhan’s TechLab
#CCNA #Routing #StaticRouting
ccna
