8 thoughts on “Bus Topology using Cisco Packet Tracer”
how to send messages in topology
Jih vaiya bujte parci sohoj ase onek apni bujanote r o sohoj lagche
O vaiya thank thank u onek boro help hoise thank u thank u big fan 😍😍😍😍😍😍😍😍😍😍😍😍😍
Sir can you recommend any theory about it ? Please
Bus – All end systems are chained to each other and terminated in some form on each end. Infrastructure devices such as switches are not required to interconnect the end devices.
Bus topologies use coaxial cable .
• Bus topology sections are connected with BNC
connectors.
• T connectors are often used to connect the
computer to the trunk cable. The T connector can
connect the computer to two sections of cable with
how to send messages in topology
Jih vaiya bujte parci sohoj ase onek apni bujanote r o sohoj lagche
O vaiya thank thank u onek boro help hoise thank u thank u big fan 😍😍😍😍😍😍😍😍😍😍😍😍😍
Sir can you recommend any theory about it ? Please
Bus – All end systems are chained to each other and terminated in some form on each end. Infrastructure devices such as switches are not required to interconnect the end devices.
Bus topologies use coaxial cable .
• Bus topology sections are connected with BNC
connectors.
• T connectors are often used to connect the
computer to the trunk cable. The T connector can
connect the computer to two sections of cable with
the bus extending in both directions.
• The end devices on the bus have terminators on
one connector of the T.
Don't we write command prompt for this plz rply
Do we have to use only generic switches?
Thanks. That was good!