How to configure SNMP in Cisco IOS devices (Router,Switch) | Enable SNMP Configuration telnet

Please watch: “Cisco L3 Core Switch IP Address | Basic Switch Configuration Commands | Assign IP Address L3 Switch”
https://www.youtube.com/watch?v=HTPg7-2bUM0 –~–
Hi guys,
I am Sunil kumar welcome to our youtube channelEdutech Idea.

About this video
how to enable snmp through command line.
Steps
Telnet to the router/switch

prompt#telnet testrouter
Go to the enable mode by specifying the password:

Router #enable
Password:
Router#
Go into configuration mode:

Router#configure terminal
Enter configuration commands, one per line. End
with CNTL/Z.
Router(config)#
Use the command below to add a Read-Only community string:

Router(config)#snmp-server community public RO
where “public” is the Read-only community string.
To add a Read-Write Community string, use the command below:

Router(config)#snmp-server community private RW
where “private” is the Read-write community string.
Exit the configuration mode and save the settings:

Router(config)#exit

source

by Edutech Idea

simple network management protocol