Computer NetworksNETWORKS

How to Find IP Address in CentOS 7

Disclaimer/Disclosure: Some of the content was synthetically produced using various Generative AI (artificial intelligence) tools; so, there may be inaccuracies or misleading information present in the video. Please consider this before relying on the content to make any decisions or take any actions etc. If you still have any concerns, please feel free to write them in a comment. Thank you.

Summary: Learn how to discover the IP address of a CentOS 7 system using command-line tools like `ip` and `ifconfig`. This guide provides step-by-step instructions for both methods, helping you quickly identify the network configuration of your CentOS 7 machine.

In CentOS 7, there are a couple of straightforward methods to find the IP address of your system. This information can be vital for network troubleshooting or system administration tasks. Below, we’ll cover two common approaches: using the ip command and the ifconfig command.

Using the ip Command

The ip command is the modern replacement for ifconfig and provides more detailed network information. Here’s how you can use it to find your IP address:

Open a terminal on your CentOS 7 system.

Run the following command:

[[See Video to Reveal this Text or Code Snippet]]

This command will display detailed network information for all network interfaces on your system, including their IP addresses.

To specifically find the IP address associated with a particular network interface (e.g., eth0 or ens33), you can use:

[[See Video to Reveal this Text or Code Snippet]]

Replace eth0 with the name of your network interface.

Using the ifconfig Command

While ifconfig is considered a legacy command, it’s still available and widely used on CentOS 7. Here’s how to use it:

Open a terminal on your CentOS 7 system.

Run the following command:

[[See Video to Reveal this Text or Code Snippet]]

This will display basic network information, including the IP addresses associated with all active network interfaces.

To filter the output for a specific network interface, you can use:

[[See Video to Reveal this Text or Code Snippet]]

Replace eth0 with the name of your network interface.

Verifying IP Address

In both cases, look for the line labeled inet followed by your IP address. Typically, it will look like inet XXX.XXX.XXX.XXX, where XXX.XXX.XXX.XXX is your IP address.

By following these steps, you can quickly identify the IP address of your CentOS 7 system using either the ip or ifconfig command. Understanding your system’s network configuration is fundamental for effective system administration and troubleshooting.

source

ipv4

Alice AUSTIN

Alice AUSTIN is studying Cisco Systems Engineering. He has passion with both hardware and software and writes articles and reviews for many IT websites.