OSPF Routing Protocol using Cisco Packet Tracer

37 thoughts on “OSPF Routing Protocol using Cisco Packet Tracer”

• ok I put a third pc too

• hi thank you, should I give static route? ping itt does not reach from pca to pcb only def. gateway.

• Nice explanation… Good introduction to ospf using "Cisco packet tracer".

• thank

• thankyou thankyou thankyouuuuuuu

• TQSM madam

• Bundle of Thanks mam❤

• thank u

• Please clarify the use of Product Id number and area number and when it change?

• You could have used RIP instead of CLI, that would have been easier.
  But Thanks for you efforts, you helped us a lot

• Thank you so much for beautiful exaplannation, it was very helpfull.😃😃😃

• Area0?

• thank you

• What does area0 mean?

• Best explanation

• This is a great video,

• NICE!!! 👍

• Hii mam I have some questions about framerelay eigrp ospfipv6 etc could you explain it please respond

• Thanks mam

• Excellent … well done …

• thank you professor

• nice explanation but I could not send from ROUTER2 to PC1 could you explain me plese ?

• in router configuration in packet tracer 6.2 I have an error in CLI. It can be solved typing
  enable
  configure terminal

• Thanks for your effort of helping us

• I'll see you in heaven 😂♥️

• bravo! very good explanation about how to set up a network inside an autonomous system

• nice

• thank you very much

• You are the best madam ❤️❣️🤝🤝🤝

• thanks!! you saved my life and dignity!!! Love u <3

• Excellent MAM. 🌹

• thank you maam

• wonderfully explained mam! thankyou!!

• I'm very happy by seeing your vedios of Cisco packet tracer mam because ours lecturers wont explain good like u that u explain . Thanku mam for good preparation for exams

• Showing in CLI invalid input detected at '^' marker while writing networks. Why?

• THANK YOU

• Superb explanation

Comments are closed.