Static NAT configuration with Cisco packet tracer

In this video I will explain you configuration of Static NAT.
NAT is used to convert Public IP Address into Private IP Address and vice-versa.

Commands for Static Nat:-

Router(config)#
Router(config)#int fa
Router(config)#int fastEthernet 0/0
Router(config-if)#ip nat inside
Router(config)#exit
Router(config)#
Router(config)#int fastEthernet 0/1
Router(config-if)#ip nat outside
Router(config-if)#ex
Router(config)#
Router(config)#ip nat inside source static 192.172.1.1 1.0.0.1
Router(config)#ip route 0.0.0.0 0.0.0.0 fa
Router(config)#ip route 0.0.0.0 0.0.0.0 fastEthernet 0/1
Router(config)#
Router(config)#
Router(config)#

Thanks for watching this video, Please LIKE, SUBSCRIBES , SHARE & COMMENT on video………..!!!

source

cisco academie